3DLAC Stick

Characteristics

• High level of fixation
• Very fast drying
• Targeted application
• Excellent adhesion
• Long lasting
• Easy application
• Water-based cleaning
• Good protection against warping of ABS, PLA, PETG ...
• Adhesion on any surface
• Intelligent fixing properties
• Product approved by the Spanish Institute of Toxicology

Application

3DLAC can be used on many materials that you want to print with 3D printers. Depending on the material, different adhesion properties can be achieved, so we recommend to perform a test before printing large parts with certain technical materials.

When removing parts, be careful how you do it. We recommend letting the surface cool bellow 30°C and, if necessary, push the part lightly to release it.

Instructions

• Over a clean and dry surface, place the container upside down and gently press the applicator against the hot bed for a few seconds and allow a small portion of the product to flow
• Spread a thin and uniform layer over the printing area for best results
• Let the product dry and start printing
• To remove the part, wait for the printing base to cool and remove

Recommendation

• Store in a cool dry place away from direct sunlight
• After each use keep the cap on

Cautions

• Do not ingest
• Avoid use by children
• Avoid contact with eyes and skin

Physical properties

• Type of binder: thermoplastic
• Colour: transparent
• Dry film thickness: 15 μ/layer
• Adhesion: 4B
• Theoretical coverage (continuous spraying): 2 m²
• Thinner: Isopropyl alcohol
• Product lifetime: >5 years
• Over-application: yes
• Heat Resistance: 200ºC
• Conditions of use: minimum ambient temperature 8ºC
• Humidity Max. 85 % R.H.P.
• Touch drying: 15 seconds
• Total drying: 45 seconds