3DLAC adhesive spray

Characteristics

• Very fast drying
• Excellent adhesion
• Long service life (more than 400 uses)
• Easy application
• Water-based cleaning
• Good protection against warping of ABS, PLA, PETG ...
• Adhesion on any surface
• Intelligent fixing properties
• Product approved by the Spanish Institute of Toxicology

Application

3DLAC can be used on many materials that you want to print with 3D printers. Depending on the material, different adhesion properties can be achieved, so we recommend to perform a test before printing large parts with certain technical materials.

A larger amount of spray helps to achieve a stronger adhesion.

When removing parts, be careful how you do it. We recommend letting the surface cool and, if necessary, push the part lightly to release it.

Instructions for use

• Shake the aerosol very well before use, approximately one minute before use.
• Apply to clean and dry surfaces. Application on glass, mirrors, aluminum and any smooth surface is recommended. On plastic surfaces we recommend to test the product behaviour first.
• For best results, apply a thin layer.
• After use, invert the aerosol to flush the valve, if the diffuser is clogged, use a cotton swab and apply a small amount of alcohol to the nozzle using a cotton swab.
• Always use 3DLAC in ventilated areas.
• Avoid application to electronic devices.
• Clean the diffuser after use to ensure it is in good condition and not clogged.
• Avoid use by children.

Physical properties

• Type of binder: thermoplastic
• Colour: transparent
• Dry film thickness: 15 μ/layer
• Adhesion: 4B
• Theoretical coverage (continuous spraying): 2 m²
• Thinner: Isopropyl alcohol
• Product lifetime: >5 years
• Over-application: yes
• Heat Resistance: 200ºC
• Conditions of use: minimum ambient temperature 8ºC
• Humidity Max. 85 % R.H.P.