Super Lube 180ml/170g - Synthetic Lubricant with PTFE

Super Lube 180 ml / 170 g is a PTFE spray lubricant for maintaining 3D printers and other precision mechanisms. It makes the most sense where you want to treat a larger area quickly and evenly, get the lubricant into harder-to-reach spots and finish the application in a moment.

Why it makes sense

• spray form for fast and even application
• PTFE for smoother movement and lower wear
• good for larger areas and harder-to-reach spots
• water-resistant formula according to the manufacturer
• wide temperature range for normal workshop and printer use

Where it fits best

Super Lube spray makes the most sense where you want to apply lubricant quickly, in a thin layer and without unnecessary spreading.

Typical use:

• linear guides
• guide mechanisms
• selected moving parts of 3D printers where quick spray application is an advantage
• larger surfaces or spots where a tube is less practical

When to choose another variant

Not every lubrication job is the same. If you know what you are lubricating, you can choose better.

• If you want longer service life and more precise dosing on a specific spot, the Super Lube 85 g tube is usually better.
• If you need very fine application in a small or hard-to-reach place, an oil applicator makes more sense.
• If you do not want a classic lubricant film and prefer a drier surface, the Super Lube DRI FILM 330 ml is the better fit.

How to apply

1. First clean the surface from old lubricant, dust and dirt.
2. Spray a smaller amount onto the required area.
3. Move the part several times after application so the lubricant spreads evenly.
4. Wipe off any excess. More does not automatically mean better.

Where not to use it

This spray is not for everything.

• the device manufacturer recommends another lubricant type
• you need very precise spot dosing without spray dispersion
• you do not want a classic lubricant film
• there is a risk of contact with belts, electronics, filament or the print surface

What to expect

This is a practical option for quick maintenance. When used in the right place, it gives you easy application, even coverage and smoother movement without unnecessary delay.

Other Super Lube variants

• Super Lube 85 g, if you want longer service life and more precise dosing
• Super Lube DRI FILM 330 ml, if you want a dry layer instead of a classic lubricant film

Technical parameters

• package: spray 180 ml / 170 g
• composition: synthetic PTFE lubricant
• colour: transparent
• temperature range: approx. -43 °C to 232 °C according to the manufacturer

FAQ

When does a spray make more sense than a tube?

Mainly when you want to treat a larger area quickly or a place where lubricant from a tube is less practical.

Is it suitable for regular 3D printer maintenance?

Yes, especially where fast and even spray application is an advantage.

Should I spray on more so it lasts longer?

No. It is better to apply a smaller amount correctly and wipe away the excess.

When should I choose another Super Lube variant?

If you want longer life and more precise dosing, choose the tube. If you do not want a classic lubricant film, DRI FILM makes more sense.