Devil Design PET-G START PACK- the set of six spools

Devil Design PET-G STARTPACK

Universal Usage

Starting set of PET-G in several colors on small spools. Try different colors without the need to buy large spools of filament. PET-G as a material combines the best features of PLA and ABS, providing easy printing, similar rigidity and excellent heat resistance. And that's why it is very popular among 3D printers.

Variety of Colors

The package contains six different colors - white - WHITE, bright yellow - BRIGHT YELLOW, red - RED, bright green - BRIGHT GREEN, blue - SUPER BLUE, and black - BLACK. This wide range will allow you to create diverse 3D prints.

Printing Recommendations

For optimal results, we recommend setting the print temperature to 220-240 °C and the bed temperature to 80 °C. If you are printing on PEI, we recommend using 3D lacquer or another adhesion preparation. It's not because PETG would not stick to PEI, it's because PETG sticks too well to PEI. Therefore, we recommend using 3D lacquer to ensure easy separation of the print from the bed later.

Storage

Due to the slightly hygroscopic nature of PETG (it absorbs moisture from the environment), we recommend storing the filaments in a dry environment, ideally in a bag with a desiccant, such as silica gel.

Packaging

The filaments are wound on clear spools with an outer diameter of 160 mm, a width of 45 mm, and a center hole of 50 mm. Each filament is carefully wound onto a spool and vacuum-sealed with a moisture absorber, ensuring that the material is ready to print right after unpacking. The total weight of the package, including the packaging, is 3.2 kg.

Technical Parameters

• Material: PET-G
• Filament diameter: 1.75 mm
• Packaging: 6x 330 g
• Outer spool diameter: 160 mm
• Inner spool hole: 50 mm
• Spool width: 45 mm
• Recommended printing temperature: 220-240 °C
• Recommended bed temperature: 80 °C