Trianglelab Heater 40W/24V

40W heating element ensures good performance - stable temperatures for your 3D prints. The heating coil is housed in a metal casing made of fine ground 304 stainless steel. The supply cable has a length of 100cm sufficient for easy application with conventional 3D printers. The lead wires are protected by fiberglass sleeve insulation with a silicone coating with heat resistance up to 250°C.

Compatibility

• Compatible with V6 heating block (Dragon, DragonFly, V6 Hotend, etc.)
• Compatible with Volcano heating block
• Firmware: RepRap, Klipper, Marlin, Repetier, Smoothieware, etc.

Parameters

• Material: ground 304 stainless steel
• Voltage: 24V
• Diameter: 6mm
• Power: 40W
• Wire length: 100cm
• Dimensions: housing Ø6 x 20mm
• Insulation: fiberglass with silicone coating, (250°C), UL3239 20AWG (200°C)