Energetic PEI smooth build plate 120mm set (Voron V0, logo)

Advantage

• Flexible, removable, holds on magnets very well
• Never deforms or rusts
• Easy to handle the first layer even if you are a beginner
• Suitable surface for various filaments, especially PLA
• No cleaning required - just bend the backing a little and fold the prints off after cooling
• Fast heating, shorter waiting time after printing.
• Long service life

Recommended temperatures

• PLA - 60°C
• HTPLA - 60°C
• PETG - 70-80°C
• PCTG - 70-80°C
• ABS - 100°C

Instructions for use of the product

PETG/PCTG/TPU - if you are not careful with the first layer, you may risk PETG/PCTG/TPU sticking to the PEI surface. This will damage the surface. To prevent surface damage, use hairspray or PVA glue before printing PETG/PCTG/TPU on PEI.

Removing parts - Before removing parts, make sure that your board temperature is close to room temperature (less than 30 C). If you remove them hot, the surface is more likely to be damaged. Gently bend the steel washer. This is easy to do and makes the process of removing the prints much easier.

To further increase surface adhesion, the surface can be lightly sanded with fine sandpaper

Use e.g. IPA to degrease the surface, do not use aggresive cleaners and solvents

Material

• 100% Genuine Ultem1000（PEI）amber color, matte finish, made in Europe
• The spring steel sheet is flat, flexible, rustproof adheres very well to magnets. Thickness 0.4 mm
• PEI is 3m tape pre-glued, no bubbles.

Packaging

• 1x spring steel plate with PEI film applied
• 1x magnetic pad with 3M adhesive surface

Parameters

• Dimension: 120 x 120 mm
• Surface material: PEI (Ultem1000, Polyetherimide)
• Plate material: Spring stainless steel
• Plate thickness: 0.4mm
• Maximum temperature: 130°C
• Color: Amber