UCAN V1.0 USB to CAN
UCAN V1.0 USB to CAN
UCAN USB adapter board using STM32F072 microprocessor
Klipper firmware support
CANable support
USB Type-C
Support CAN 2.0A, 2.0B up to 1M baud rate
Compatibility Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone ... More
Manufacturer: FYSETCProduct code: 588 Shipping and Payment
UCAN USB adapter board using STM32F072 microprocessor
Klipper firmware support
CANable support
USB Type-C
Support CAN 2.0A, 2.0B up to 1M baud rate
Compatibility Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone ... More
Manufacturer: FYSETCProduct code: 588 Shipping and Payment
UCAN is a small inexpensive open source USB to CAN adapter, compatible with CANable hardware. UCAN acts as a virtual serial port on the computer and acts as a serial link for the CAN bus interface. With the alternative Candlelight firmware, UCAN works as a native CAN interface on Linux. The UCAN adapter is compatible with ARM-based embedded platforms such as Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone, etc. It can also be used as a USB to CAN application on Klipper.
Features
- Uses STM32F072 processor
- USB Type-C connector
- Supports CAN2.0A and B, baud rates up to 1M
- Compatible with CANable
- Support CAnable / CandleLight / Klipper firmware
- 3-pin screw terminal: CANH, CANL, GND
- Jumper to enter bootloader for firmware update
- Default 120R on-board termination or jumper to enable/disable termination
Package Contents
- 1x PCB
- 1x Connector
Manufacturer | FYSETC |
---|---|
Recommended by Voron Community | Yes |
Voron | V2.4|Trident|Switchwire |
Voron Mod | StealthBurner|Clockwork2 |
Microprocessor | ARM 32-bit Cortex-M0|STM32F072 |
Processor frequency | 48Mhz |
USB type | USB-C |