Magigoo Pro PP-GF adhesive

Magigoo Pro PP-GF adhesive


Build plate adhesive for glass fibre filled polypropylene (PP-GF) and standard PP. Releases the part after cooling. Wear gloves when handling. More

Manufacturer: MagigooProduct code: 612 Shipping and Payment

35,35 € incl. VAT
In stock
pcs
(5 pcs in stock)

Build plate adhesive for glass fibre filled polypropylene (PP-GF) and standard PP. Releases the part after cooling. Wear gloves when handling. More

Manufacturer: MagigooProduct code: 612 Shipping and Payment

Magigoo Pro PP-GF is a build plate adhesive for 3D printing glass fibre filled polypropylene (PP-GF, GFPP). These filaments are strong and stiff but warp heavily during printing, so the adhesive makes sense for technical and industrial PP-GF parts. The manufacturer also lists it for standard PP. It holds the part while the bed is hot and releases it once the bed cools. The 50 ml bottle has a valved applicator.

For PP-GF and polypropylene

It works on glass, Kapton, PEI and similar surfaces. Set nozzle and bed temperatures according to the filament manufacturer: start at the lower end of the range and raise the bed temperature in 5 °C steps. The manufacturer recommends an enclosed printer and a single-layer 20 mm brim.

The part releases once the bed has cooled by around 30 to 40 °C below the printing temperature. If it still sticks, reheating the bed to 60 to 80 °C helps, as the adhesive layer is softer then. Peel the brim away first, then lift the part; in case of excess adhesion, work a little water underneath it. Removing the part disrupts the adhesive layer, so renew it before the next print.

How to use Magigoo Pro PP-GF

  1. Shake the bottle for 3 to 5 seconds. Put on gloves.
  2. Press the tip against a clean, cold build plate to open the spring valve and spread a thin, even layer without gaps. Do not squeeze the bottle with the tip exposed.
  3. Start printing; there is no need to wait for the adhesive to dry.
  4. After printing, let the bed cool and remove the part as described above.
  5. PP-GF adhesive residue dissolves more slowly than other Magigoo adhesives. Let it soak in water for a while, scrub the loosened layer off with an abrasive sponge and wipe the plate with a damp cloth.
  6. Store the bottle upright, capped and away from direct sunlight. After use, wipe excess adhesive off the rim of the tip, otherwise the tip may stick to the cap.

Safety

  • The adhesive contains components that cause serious eye damage on contact. Protect your eyes.
  • Wear protective gloves.
  • Wash hands and exposed skin thoroughly after handling.
  • Incompatible materials according to the technical data sheet: iron, copper, zinc.
  • Full information is given in the manufacturer's safety data sheet.

Specifications

Volume50 ml
Intended forPP-GF (GFPP), PP
Build surfacesGlass, Kapton, PEI and similar surfaces
BaseWater
Applicator24 mm foam tip with spring valve
CleaningWater and a damp cloth
Manufacturer codeMPPGF2019
Country of originMalta

Documentation

Parameters
Manufacturer Magigoo
Filament material PP, PP-GF
Country of origin Malta
Volume 50 ml