Magigoo Pro PP adhesive
Magigoo Pro PP adhesive
Build plate adhesive for polypropylene and PP composites. Holds on a hot bed and loosens the part after cooling. Wear gloves when handling. More
Manufacturer: MagigooProduct code: 608 Shipping and Payment
Build plate adhesive for polypropylene and PP composites. Holds on a hot bed and loosens the part after cooling. Wear gloves when handling. More
Manufacturer: MagigooProduct code: 608 Shipping and Payment
Magigoo Pro PP is a build plate adhesive for 3D printing polypropylene and PP composite filaments. Polypropylene barely sticks to common build surfaces and larger parts warp, so it is hard to print without a suitable adhesive. The adhesive holds the part while the bed is hot and loses its grip once the bed cools. The 50 ml bottle has a valved applicator.
For polypropylene
It works on glass, Kapton, PEI and similar surfaces. Set nozzle and bed temperatures according to the filament manufacturer: start at the lower end of the range and raise the bed temperature in 5 °C steps. For larger parts or when warping occurs, the manufacturer recommends a 20 mm brim, multi-layer if needed.
Once sufficiently cooled, the part becomes easier to remove, according to the manufacturer within 30 minutes of the print finishing at most. Peel the brim away first, then lift the part. If it sticks too firmly, work a little water underneath it or use a scraper.
How to use Magigoo Pro PP
- Shake the bottle for 3 to 5 seconds. Put on gloves.
- Press the tip against a clean, cold build plate to open the spring valve and spread a thin, even layer without gaps. Do not squeeze the bottle with the tip exposed.
- Start printing; there is no need to wait for the adhesive to dry.
- After printing, let the bed cool and remove the part as described above.
- Wet the adhesive residue with a wet sponge. The wetted layer loosens and can be scrubbed off with an abrasive sponge; finally wipe the plate with a damp cloth and dry it with a paper towel.
- Store the bottle upright, capped and away from direct sunlight. After use, wipe excess adhesive off the rim of the tip, otherwise the tip may stick to the cap.
Safety
- The adhesive contains components that cause serious eye damage on contact. Protect your eyes.
- Wear protective gloves.
- Wash hands and exposed skin thoroughly after handling.
- Incompatible materials according to the technical data sheet: iron, copper, zinc.
- Full information is given in the manufacturer's safety data sheet.
Specifications
| Volume | 50 ml |
|---|---|
| Intended for | PP and PP composites |
| Build surfaces | Glass, Kapton, PEI and similar surfaces |
| Base | Water |
| Applicator | 24 mm foam tip with spring valve |
| Cleaning | Water and a damp cloth |
| Manufacturer code | MPP2018 |
| Country of origin | Malta |
Documentation
| Manufacturer | Magigoo |
|---|---|
| Filament material | PP |
| Country of origin | Malta |
| Volume | 50 ml |