Magigoo Pro PC adhesive
Magigoo Pro PC adhesive
Build plate adhesive for polycarbonate and PC-ABS and PC-PBT blends. Holds on a hot bed and releases the part after cooling. Cleans with water. More
Manufacturer: MagigooProduct code: 609 Shipping and Payment
Build plate adhesive for polycarbonate and PC-ABS and PC-PBT blends. Holds on a hot bed and releases the part after cooling. Cleans with water. More
Manufacturer: MagigooProduct code: 609 Shipping and Payment
Magigoo Pro PC is a build plate adhesive for 3D printing polycarbonate and its PC-ABS and PC-PBT blends. Polycarbonate needs a high bed temperature and tends to warp, so the adhesive makes sense for functional and technical PC parts. It holds the part while the bed is hot and releases it without tools once the bed cools. The 50 ml bottle has a valved applicator.
For polycarbonate only
The manufacturer optimised the adhesive for PC and lists PC-ABS and PC-PBT blends as compatible. It was tested with Polymaker PolyMax PC, PolyLite PC and PolyMax PC-FR. It works on glass, Kapton, PEI and similar surfaces. According to the manufacturer, using it with filaments other than PC may cause over-adhesion and damage the build surface.
Set nozzle and bed temperatures according to the filament manufacturer; the adhesive manufacturer expects a bed at 100 to 120 °C or more and recommends an enclosed printer. A raft or brim helps with larger parts. According to the technical data sheet, the adhesive decomposes during extended periods at 130 °C or more. Check your calibration: a nozzle too close to the bed causes excess adhesion.
How to use Magigoo Pro PC
- Shake the bottle for 3 to 5 seconds.
- Clean the plate with water. Press the tip against the clean, cold plate to open the spring valve and spread a thin, even layer without gaps. Do not squeeze the bottle with the tip exposed.
- Start printing; there is no need to wait for the adhesive to dry.
- After printing, let the bed cool. According to the data sheet, a temperature drop of 30 to 40 °C is usually enough to remove the part without tools.
- Wipe the plate with a damp cloth; water is all you need. Store the bottle upright, capped and away from direct sunlight; rinse a dried tip with water.
Specifications
| Volume | 50 ml |
|---|---|
| Intended for | PC (optimised), PC-ABS, PC-PBT |
| Bed temperature | Per filament, the manufacturer states 100 to 120 °C or more |
| Build surfaces | Glass, Kapton, PEI and similar surfaces |
| Base | Water |
| Applicator | 24 mm foam tip with spring valve |
| Cleaning | Water and a damp cloth |
| Manufacturer code | MPC2018 |
| Country of origin | Malta |
Documentation
| Manufacturer | Magigoo |
|---|---|
| Filament material | PC, PC-ABS, PC-PBT |
| Country of origin | Malta |
| Volume | 50 ml |