Magigoo Pro PA adhesive

Magigoo Pro PA adhesive


Build plate adhesive for PA6, PA12 and PA66 nylon and glass or carbon fibre reinforced nylon. Releases the part after cooling, cleans with water. More

Manufacturer: MagigooProduct code: 605 Shipping and Payment

22,85 € incl. VAT
In stock
pcs
(5 pcs in stock)

Build plate adhesive for PA6, PA12 and PA66 nylon and glass or carbon fibre reinforced nylon. Releases the part after cooling, cleans with water. More

Manufacturer: MagigooProduct code: 605 Shipping and Payment

Magigoo Pro PA is a build plate adhesive for 3D printing nylon (polyamide). Nylon adheres poorly to common build surfaces and tends to warp, so the adhesive suits anyone printing functional and technical parts from PA. It holds the first layer while the bed is hot and releases the part once it cools. The 50 ml bottle has a valved applicator.

For nylon and reinforced nylon

The manufacturer optimised the adhesive for PA12 and PA6 and lists PA66 and glass or carbon fibre reinforced nylon (PA-GF, PA-CF) as compatible. It was tested with filaments including Luvocom 3F PAHT. It works on glass, Kapton, PEI and similar surfaces. According to the technical data sheet, the adhesive decomposes during extended periods at 130 °C or more.

Set nozzle and bed temperatures according to the filament manufacturer. Raising the nozzle or bed temperature by 5 to 10 °C for the first layer helps adhesion; for larger parts the manufacturer recommends a 20 mm brim. Wet nylon adheres worse, so dry the filament before printing as its manufacturer recommends.

How to use Magigoo Pro PA

  1. Shake the bottle for 3 to 5 seconds.
  2. Clean the build plate with water and then isopropyl alcohol. Apply the adhesive to a cold plate only, never to a hot one.
  3. Press the tip against the plate to open the spring valve and spread a thin, even layer without gaps. Do not squeeze the bottle with the tip exposed.
  4. For larger or demanding parts, apply a second layer once the first has dried.
  5. Start printing. After printing, let the bed cool; according to the data sheet, a drop of around 40 °C is usually enough. If the part sticks too firmly, work a little water underneath it.
  6. Wipe the plate with a damp cloth; water is all you need. Store the bottle upright, capped and away from direct sunlight; rinse a dried tip with water.

Specifications

Volume50 ml
Intended forPA12 and PA6 (optimised), PA66, PA-GF, PA-CF
Build surfacesGlass, Kapton, PEI and similar surfaces
BaseWater
Applicator24 mm foam tip with spring valve
CleaningWater and a damp cloth
Manufacturer codeMPA2019
Country of originMalta

Documentation

Parameters
Manufacturer Magigoo
Filament material Nylon (PA)
Country of origin Malta
Volume 50 ml