Magigoo Pro Kit adhesives

Safety

These products are for professional use. Please read the instructions carefully before use. 

Using this product with other than designated type filaments might cause over adhesion and damage your build surface.

Some products may have corrosive and eye irritation substances. Wash your hands after use. Ideally use rubber gloves. Read Safety Data Sheets or consult with manufacturer if necessary. 

The bottle applicator has a spring valve inside. In order to activate it, press the nib against the build plate firmly. When pressing bottle sides, make sure the applicator is not going to pop out.  

Tips

For larger prints a 20 mm brim is recommended

In cases of excess adhesion, it is recommended to wet the print bed with a small amount of water slowly working it below the part, this should make part removal easier.

Application Method

Step 1: Shake it like you mean it.

Shaking too much might cause bubbling. This does not negatively affect adhesion but will not provide a mirror finish on the bottom of the print.

Step 2: Press nib against the surface.

The Magigoo container is spring activated. Pressing the bottle without pressing the nib against the bed may results in applicator popping off and product wastage.

Step 3: Apply to Desired area

The best and most reliable performance is achieved when applied as a thin layer. This means that cleaning and re-applying between prints is recommended especially on longer prints or hard to print with materials.

Step 4: Print

After print, wait until the build plate is cool to remove prints easily.

Step 5: Clean

For cleaning - Just wipe off with a damp cloth. Yes, it’s that easy.